The Influence of Cone Beam Computed Tomography-Derived 3D-Printed Models on Endodontic Microsurgical Treatment Planning and Confidence of the Operator.

[INTRODUCTION] Currently, there are no studies evaluating the impact of 3-dimensional (3D) printed models on endodontic surgical treatment planning. The aims of this study were: 1) to determine if 3D models could influence treatment planning; and 2) to assess the effect of 3D supported planning on operator confidence.

[MATERIALS] Endodontic practitioners (n = 25) were asked to analyze a preselected cone beam computed tomography (CBCT) scan of an endodontic surgical case and answer a questionnaire that elucidated their surgical approach. After 30 days, the same participants were asked to analyze the same CBCT scan. Additionally, participants were asked to study and to perform a mock osteotomy on a 3D printed model. The participants responded to the same questionnaire along with a new set of questions. Responses were statistically analyzed using chi square test followed by either logistic or ordered regression analysis. Adjustment for multiple comparison analysis was done using a Bonferroni correction. Statistical significance was set at ≤0.005.

[RESULTS] The availability of both the 3D printed model and the CBCT scan resulted in statistically significant differences in the participants' responses to their ability to detect bone landmarks, predict the location of osteotomy, and to determine the following: size of osteotomy, angle of instrumentation, involvement of critical structures in flap reflection and involvement of vital structures during curettage. In addition, the participants' confidence in performing surgery was found to be significantly higher.

[CONCLUSIONS] The availability of 3D printed models did not alter the participants' surgical approach but it significantly improved their confidence for endodontic microsurgery.