임상 질문으로 논문 찾기

…ter-based objective photogrammetric analysis of nasal symmetry (nostril height, nostril width, nostril area, alar height, and alar width parameters). [RESULTS] Significant d…

… nasal tip projection, nasal dorsal angle, and nasal tip angle in lateral view; nostril width, nostril height, and nasal tip height in basal view were measured at preoperati…

… Nasal changes were analysed by measuring nasal tip projection, nostril height, nostril width, alar base width, and nasal gap area preoperatively and postoperatively on stan…

…t to width ratio, and bilateral nasal symmetry index (including nostril height, nostril width, and nostril height to width ratio). [RESULTS] The incisions healed by first in…

…ht, dome height, alar base width, nostril height to width ratio, dome height to nostril width ratio, nasolabial angle and columella deviation were measured on preoperative a…

…e corrective operations with complete survival of all implanted cartilages. The nostril width was narrower in postoperative group (P < 0.05). The nostril height and long axi…

…s used to measure parameters on three-dimensional photographs: nostril heights, nostril widths, nasal dorsum heights, alare width, nostril areas, overlapping nostril area, n…

… inclination angle) were used for evaluation of aesthetic results. The ratio of nostril width, height and gap area between the cleft side and the non-cleft side showed signi…

…phs of cleft rhinoplasty patients were evaluated using a standardized protocol. Nostril width ratio, columellar angle, tip projection ratio, and nasolabial angle served as o…

… as the rim graft, and 59 patients did not. Measurements of the nostril height, nostril width, one-fourth medial part of nostril height, nostril area, nasal dome height, and…

…lure. The nasal shape was flatter with a decreased nostril height and increased nostril width after alveolar bone grafting, while nostril height was increased and nostril wi…

… (al-ch) were used to evaluate the effect of mucoperiosteal dissection, whereas nostril width, height, and angle were used as proxies to evaluate the effects of tip rhinopla…

… analyses were performed and compared with age-matched normal values. [RESULTS] Nostril width (UCL = 1.01, UCLP = 1.03) and nostril floor width (UCL = 1.02, UCLP = 1.04) wer…

…91%), wide nasal bones (47%), drooping nasal tip (78%), septal deviation (85%), alar flaring (38%), bulbous nasal tip (81%), and nostril asymmetries (76%). These anatomical…

…e the appearance of a plunged nose. Treatment of the dilator naris can minimize alar flaring, giving the appearance of a thinner nasal tip. These methods primarily reported…

…re employed for postoperative evaluations. [RESULTS] In the experimental group, alar flaring mobility decreased from 10.05% ± 6.40% to 4.91% ± 3.48%(P < 0.05), and alar bas…

…ted through equation: [Formula: see text]. [RESULTS] Alar mobility consisted of alar flaring mobility and alar base mobility. The alar flaring mobility was (9.49 ± 4.90)%, …

…esthetics and provide a treatment algorithm for common deformities that include alar flaring and a wide nasal base. The authors attempt to provide a comprehensive approach …

…dvancement techniques and cinching suture in 40 patients (2.5%). When excessive alar flaring was present, alar wedge resection was preferred in the 92% of followed by alar …

…e and increase alar harmony. If the nasal tip analysis shows malpositioned LLC, alar flaring, an over-projected nasal tip, mild retraction, or contour asymmetries, this typ…